Semi-Automatic Water Level Controller Circuit Project Using 555 Timer With Indicator

Semi-Automatic Water Level Controller Circuit Project Using 555 Timer With Indicator. Manual On and auto off.

A semi-automatic water level controller circuit utilizing the versatile 555 timer IC presents an innovative solution for efficient water management. This unique circuit ensures precise control over water levels by employing a combination of sensors and the reliable 555 timer IC. By integrating these elements, this semi-automatic water level controller offers a hassle-free approach to maintaining optimal water levels in various applications. With its cutting-edge technology, this circuit promises to revolutionize water management, providing convenience while conserving this precious resource.

A semi-automatic water level controller circuit is used for automatically controlling the level of water in a tank and avoid overflowing. This circuit is made up of a sensor, timer chip, relay, pump driver and power supply. The sensor senses the water level in the tank and converts it to voltage. The timer chip takes care of sensing voltage from sensor and turns ON/OFF pump driver accordingly.

This is a very simple water controller circuit built using the popular 555 timer ic. It is called as semi-automatic water level controller because we have to manually switch on the circuit and it will turn off the water pump automatically once the level of water touches the contact type sensor placed at the top of of the water tank. Instead of using contact type sensors, we can also use magnetic float switches.

Parts Required:

DB1 – Bridge rectifier DB107

IC

U1 – 7810 or 7812

U2 – NE555 Timer ic

Resistors: (All 1/4W)

R1 – 4.7K

R2 – 100K

R3 – 10K

R4 – 4.7K

R5 – 2.2K

R6 – 47K

Capacitor:

C1 – 100uF/ 25V

C2 – 0.001uF ceramic

C3 – 0.01uF ceramic

Diode D1 – In4007

Led

L1 – Red, L2 – Green

S1 – Momentary Switch (Normally Open)

Q1 – Transistor 2N2222

RY1 – 12V Relay

Led L1 is used to indicate the power whereas the Led L2 is used to indicate motor is running. 555 timer is wired in bistable mode.Motor is turned on by pressing the switch S1 momentarily that is connected to the pin 2 of the timer ic. We can also connect another momentary switch across the pin 6 and the positive rail of the circuit to turn off the motor if required.The output of the timer is fed to the base of the npn transistor to drive a 12V relay. We can use more ampere rating relay to drive high Hp motors.